Share your CCNA Wireless Experience

guys, what is right now? the questions from the doc ist the actual dump?

Passed the test som day ago with 9xx points
The question about “What are the sources of interference you will find when conducting a site survery before deployment”.
I think that the correct answer is Bluetooth headset, microwave owen and analog wireless camera. They are asking about interference sources and the other alternatives is native 802.11 traffic

About SNR for 54Mb/s. When googling at the internet I find documents that says 19, 21/22 or 25dB. Cisco says 25 dB for some of theirs wireless IP-phone and the other alternatives at the test is far away from 25dB

It is also som new question at the test, but with good knowledge to the OCG, wireless videosessions form ciscolive.com and all cwnp-tv videos at YouTube it should be “god to go”

please, how can i get free 410 dump ?
can anyone help me .

QUESTION 121
Which three items are allowed on an Ethernet trunk port? (Choose three.)
A. autonomous AP
B. FlexConnect AP
C. local AP
D. monitor AP
E. rogue detector AP
F. sniffer AP
G. SE-Connect AP
H. Cisco WLC

Is correct answer ABE or BEH?

@Steven. Thanks for your answer.
I did not study 410Q as it has a lot of questions, i just studied 103q and DOC, i’m a little afraid that might have another questions from 410Q.

@Shea there is a lot of different answers of this. See the one that i think its correct:

B, E, H

FlexConnect , Rogue detector , WLC ==> all of them REQUIRE a trunk port to work.

Answer “A” maybe correct if we had to pick 4 items, but an Autonomous AP CAN work in access mode if we have only one VLAN. It can also work in trunk mode IF we have multiple VLANS but it’s not mandatory .

@ciscoboy, did you get the questions from what Dump? Also do you remember any question for us to add on our ‘DOC’?

Hello!
is there any premium account
or PDF dumps for this exam here please??

@Steven. Why did you chose AdHoc Hotspot? In the official book and on the internet you can read that bluetooth and bluetooth headset as source of interference. That must be one of the correct answer. I can’t find anything in the book about adhoc hotspot to be a source of interference.. Please give me some feedback :)

http://blogs.cisco.com/wireless/interference-detection-and-mitigation-with-cisco-cleanair

“NEW 6:
What are the sources of interference you will find when conducting a site survery before deployment(Something like that)?

1-Bluetooth Headset
2-Microwave Ovens
3-Analog Wireless Camera
4-AdHoc Wireless Camera
5-AdHoc Hotspot

Answer: 2,3,5”

Made it, 9xx. (411 no wcs no dragdrop) +doc is enough. Good luck everyone

Q “about roaming generally, what is valid” ? not inter, that Q was also there
Q “how to download code file to wlc” , I picked “download tftp//.. ”
Q “Having several wlan/APs pointing to different dhcp severs. where in the wlc gui can you find this”?

Many 3 option was down to 2 option, some answer text were changed.

Hello all anyone has 411Q on .VCE format?
Please email me: guilherme1846 at hotmail dot com

all thanks for my god
guys
passed yesterday
plsssss be careful.. approximately third of questions are outside the dumps or made modified two choice rather than three choice
good luck all

concentrate on new q fom steven and imm that are included in the last editing for the doc

Here are one question from my test
In an excisting network with autonomous APs and you install new APs. How do you access the new APs?
1. Http to the ap dhcp address
2. HTTPS to the ap DHCP address
3 and 4. HTTP/HTTPS to 10.0.0.1
5 and 6. HTTP/HTTPS to 198.168.0.1

I assumed because of an excisting network that there is an dhcp-server installed on the network,so it’s either http or HTTPS to the APs DHCP-address.
I do think I selected to HTTPS to the APs dhcp-address. I not sure if it’s choise 1 or 2 that is correct. The browser select it automatically, I think

Guys, just pass today!! study 411q and the doc from steven and IMM, just 2 or 4 new question but really easy..

Good luck!

Hello guys, here is 411q + doc file + IMM file in one link

https://drive.google.com/open?id=0BzQDRVInAZVCeHJrdGdZNllfem8

feedback is really important, please share with us if you pass or not, also please share with us if you saw any new questions in the exam, good luck ;)

Hello all anyone has 411Q on .VCE format?
Please email me: relj at msn dot com

Hi!

Congratulations!

I just passed my 200-355 exam last weekend!!!

There were NO NEW questions in the exam!

I learned all questions from passleader 200-355 dumps!

Still 100% valid now!!!

PassLeader 200-355 dumps with PDF and VCE (410q):

http://www.passleader.com/200-355.html

……

Part of FREE VERSION of premium PassLeader 200-355 dumps on Google Drive:

https://drive.google.com/open?id=0B-ob6L_QjGLpcXZkRGszbGJmUkE

Good Luck!!!

Morning Guys, i just merge IMM’s and ‘doc file’ just to ‘doc file’.

Also i double checked some of the new questions. I Do not had time to do it for all, so i need your guys help to do it, and post in here and i will updated the file for us.

https://drive.google.com/open?id=0Bx1YGbI8lbwQa25pQl80WnU4UFE

CISCO , Microsoft exam voucher Available price

CCNA 22500 PRK
CCNp 23500 PRK

Contact Name: Vicky
Contact Nunber: 0092-0300 87 58 879

Can anyone let me know about latest dump? i need to give exam before Nov 16.

Can you guys suggest a valid dump link to download, pls?

Someone passed?

Hi Guys, anybody have 300-360 valid dump with 70Qs? please share the link, really urgent, You guys also will need it after CCNA wireless.

Question 75 from DOC

What does the current ETSI rule state is the 2.4GHz max Tx output power for P2P installations?
A. 16dBm
B. 17dBm
C. 20dBm
D. 30dBm
E. 36dBm

Dump says B is the right answer. I cannot agree to this.

a) As opposed to FCC, ETSI doesn’t care if it’s P2P or P2M… so there are no special rules for P2P links
b) ETSI says max EIRP can be no more than 20dBm for 2.4GHz… any combination of Tx and Antenna Gain can be used!

Therefore, the correct answer for this one should be C.

Q153
Which four options are the characteristics of the original 802.11 protocol? (four)

a) Defined DSSS and FHSS as possible methods of modulation
b) Designed to operate in 5GHz
c) The most common deployment is three non-overlapping channels that are 20MHz wide
d) The protocol sets the maximum throughput at 1 or 2Mbps
e) Defined FHSS and OFDM as possible methods for modulation
f) The most common deployment is three non overlapping channels that are 22MHz wide
g) Designed to operate in 2.4GHz ISM frequency spectrum
h) The protocol sets the max throughput at 1Mbps

Answer: acdg

Completely wrong.
Correct answer is adfg. That is, original 802.11 (it’s not even 802.11b, it’s 802.11-1997) can only support FHSS/DSSS with 1 and 2Mbps rates. When DSSS is used then we have 3 non overlapping channels 22MHz wide each (not 20!!! 20 is OFDM). 802.11 was 2.4GHz only.

Q 268
How many types of control frames are only used in PCF mode?

a) 0
b) 1
c) 2
d) 3
e) 4
f) 5

Answer: d (3)

Is this question still part of the exam? Apparently it’s not covered by Official Cert Guide anymore. The last place where I saw this topic to be covered was CCNA Wireless 640-721 by Brandon James Carroll, where he lists 5 PCF control frames:

CF+End
CF+end_ack_
CF-Ack
CF Ack+CF Poll
CF-Poll

However, I am not sure this question is in current exam blueprint. Can anyone confirm?

Q75
When AP in its default configuration mode connects to a Cisco WLC, which methods are available for remote management access to an AP?

a) SSL and SSH are avilable only after configuration by a Cisco WLC v7.0
b) SSH only
c) HTTPS and SSH
d) SSH and Telnet
e) SSH and Telnet are avilable only after configuration by a Cisco WLC v7.0

Answer: d

Eh? How is this possible? I am working with CUWN for ages and as far as I am aware, without configuring SSH/Telnet access on the WLC there’s no other way to manage LWAP, except Console! So, correct answer should be E

@TD.. can you please share link for getting latest dump?

@Brian, I don’t have them. I have downloaded few versions from links listed on previous pages and went through all those… they seem to be ok, I only struggle with WCS questions, which are not in the exam anymore as far as I am aware. I am going to take exam on Wednesday. Still need to go through my notes… I hate CCNA level exams… too much everything about everything. I will be preparing to CCNP Wireless Security right after it. Need to sort it before end of year to make sure my CCNP R&S does not expire.

@TD thanks. Do share your experience after exam.All the best.

Passed 200-355 exam yesterday!!!

It seems NO NEW questions in my actual 200-355 exam!

PassLeader 410q dumps are still valid!

Here the PL 410q for free:

https://drive.google.com/open?id=0B-ob6L_QjGLpcXZkRGszbGJmUkE

Thank you all and GOOD LUCK!!!

@Nimz

Free 300-360 dumps:

https://drive.google.com/open?id=0B-ob6L_QjGLpWVVreDl3bGRhakk

@David,Thanks much for sharing dump link. Anyone else please share your experience.

Exam tomorrow after failed first attempt. Will update tomorrow.

@Simonster, please share your experience. All the best. Do let us know validity of dump 411q

someone passed? last time?

Passed but only just. Need dumps and knowledge. Some of the Q’s have 2 to 3 answers and dumps give 3 or 4 answers. Answers are not in order. Also use the word doc someone posted.

Congratulation Simonster.

May I ask if there any questions about WCS.
Because there are many of them at Q411 DUMP.

Thanks for your experience sharing.

none on wcs navigation, no drag and drops.

@David Miller,
i have this but it has only 55 Qs. I am looking for 70Q dump.

Dears

Please what the correct answer here

Which three items are allowed on an Ethernet trunk port? (Choose three.)
A.autonomous AP
B.FlexConnect AP
C.local AP
D.monitor AP
E.rogue detector AP
F.sniffer AP
G.SE-Connect AP
H.Cisco WLC

In the doc sayed ” A,B,E”

But I think correct answer should be ” B,E,H”. Because WLC interface worked under trunk to allowed different VALNS .

Dears

I passed the exam.
Thanks for ever one shared his knowledge and exam experience.
There are some new 5 to 6 new questions
But if study Q411 and doc very well I thank you can pass.
Personally I studied from cbt videos and Q411 and Doc.

There is no drag drops, no WCS QUESTIE.

Q
How many types of control frames are only used in PCF mode?
The answer is 3. Because in the exam there is no 5 option coming.

Question
How can you connect hidden SSID by using MAC IOS laptops.
I am not sure what the answer.
But I selected.
parameter from wireless settings ” something like that “

passed today with 930/1000
used cbt nuggets, official cert guide and went through 410q
no questions re wcs, or prime…

PCF frames – apparently 3, they even removed 5 from the answer list so that people don’t get confused
hidden SSID on iOS device -> Wireless > Other (you have to manually enter SSID)

Get free 642-722 exam sample questions with valid answers from http://www.dumps4download.us/free-640-722/cisco-question-answers.html

Passed my 300-115 Exam, Score 940/1000 I would like to thanks http://pass4surekey.com/exam/300-115.html they have updated dumps.