Share your CCNA Wireless Experience

@JSMITH
https://drive.google.com/open?id=0B-ob6L_QjGLpcXZkRGszbGJmUkE
IT MUST BE U HAVE A GOOGLE ACCOUNT

AYMAN

by chance can you share with us which questions you saw on the test any drag and drop

where most of the questions from 410q or 103 or 291 please advise

Guys i have copied and pasted all the questions provided from previous test takers into this doc which is 37 question as of know can anyone that has recently taken the exam pass or fail add questions they saw on the exam and re-upload doc….

The questions are from Err which where from a few pages back based on what he/she saw on the test from the 291q

https://drive.google.com/file/d/0Bx7fP4On5BVleUlxblFNUERwZDQ/view?usp=sharing

Added the 10 questions that Abug mentioned

https://drive.google.com/file/d/0Bx7fP4On5BVleUlxblFNUERwZDQ/view?usp=sharing

@steven
thanks steven … this questions included abuG questions is not it

Hey cisco man

The 10 question added where from the link Abug provided a page ago. I will look through the 410q dump and see if i can find the questions he refferenced to a few comments ago.

Are those the ones you were reffering to cisco man ?

@steven
more thanks steven

Hello Guys and @Steven! I just review steven’s document and added some new question that i found here in the forum. Please help us with the correct answers and new questions:

https://drive.google.com/open?id=0Bx1YGbI8lbwQa25pQl80WnU4UFE

hey guys these are the only debugging questions I was able to find on the 410q along with the DFS channels

QUESTION 243
Which two actions would you use to begin to troubleshoot an access point that fails to join a wireless LAN controller successfully? (Choose two.)
A. SSH to the AP.
B. SSH to the Cisco WCS.
C. SSH to the Cisco WLC.
D. Issue the Cisco WLC commandebug capwap events enable
E. Issue the Cisco WLC commanshow capwapevents
Correct Answer: CD

QUESTION 268
Which Cisco WLC command family can help to troubleshoot communication between an AP and the WLC?
A. (Cisco Controller) >debug capwap
B. (Cisco Controller) >debug ap
C. (Cisco Controller) >debug cac
D. (Cisco Controller) >debug dot11
Correct Answer: A

QUESTION 108
Which three WLC debug commands are appropriate to troubleshoot a wireless client that is associated to an AP? (Choose three.)
A. debug capwap
B. debug mac addr
C. debug dot11
D. debug dhcp
E. debug ap
F. debug dtls
Correct Answer: BCD

Dynamic Frequency Selection Channels
When a DFS–enabled radio is operating on one of the following channels, the wireless device uses DFS to monitor the operating frequency and switch to another frequency or reduce power as necessary:
• 52 (5260 MHz)
• 56 (5280 MHz)
• 60 (5300 MHz)
• 64 (5320 MHz)
• 100 (5500 MHz)
• 104 (5520 MHz)
• 108 (5540 MHz)
• 112 (5560 MHz)
• 116 (5580 MHz)
• 120 (5600 MHz)
• 124 (5620 MHz)
• 128 (5640 MHz)
• 132 (5660 MHz)
• 136 (5680 MHz)
• 140 (5700 MHz)

The one that comes closes to Abugs comments is question 243

updated doc

https://drive.google.com/file/d/0Bx7fP4On5BVleUlxblFNUERwZDQ/view?usp=sharing

how many drag&drop questions in the exam ??

from what others have posted on page 43 no drag and drop….It would be nice if the few that failed the test would chime in with their experiences and validate the doc we keep uploading

thanks steven

thanks steven,

What another dump should study with your updated doc?

the only dumps im aware of is 291q 103q and 410q also if you need through a VCE simulation which i find very helpful you can go to exams for all http://examsforall.com/ and download the latest 200-355 VCE file i was playing with it yesterday and noticed a lot of the same questions on the pdf dumps are also on the VCE file. Besides that hopefully individuals that take the test can help validate the doc we have going on and or include additional questions. I scheduled my exam for next friday so I will continue to study from the doc. and 103q and 291 to prep for the test. Its funny, I got a few years working with Wireless systems and some of the questions on these test dumps are ridiculous, not to mention the 3 answer questions make it harder. I have my CWNA certification and found it much easier and realistic real world scenarios on that exam.

Thanks a lot Steven, i’l take my exam the next friday too, good luck !

guys
in this question at passleader 291 dump
Which statement about the impact of configuring a single SSID to support TKIP and AES encryption simultaneously is true?

A. The overhead associated with supporting both encryption methods significantly degrades client throughput.
B. Some wireless client drivers might not handle complex SSID settings and may be unable to associate to the WLAN.
C. This configuration is unsupported and the Cisco Wireless Control System generates alarms continuously until the configuration is corrected.
D. This configuration is common for migrating from WPA to WPA2. No problem is associated with using this configuration.

his choice is B but his explane says the correct answer is D
i’m personaly choose the D
any comment ????

(A) might be the correct answer. Choose the both encryption scheme will slower the network speed.
http://www.howtogeek.com/204697/wi-fi-security-should-you-use-wpa2-aes-wpa2-tkip-or-both/

It is not A, aes is hardware based, so no overhead.

@cisco man

In one of the videos by Keith Barker, he mentions that WPA+TKIP+AES is a valid combination but that some clients might not be able to handle that complexity or combination.

I’d probably pick B.

Hey Steven,

Can you also upload that 410q doc you have?
Seems there is a 411q wondering around and I would like to check if its the same one.

@Cisco man

Answer should be B for the question above

Chuck,

The dump i have is the 411q not sure why i wrote 410q…

https://drive.google.com/file/d/0Bx7fP4On5BVlVVhIQTc4cTNNcXM/view?usp=sharing link to 411q

thanks steven
steven by away dumps 291&103q only are enough no 411q dump with them ???

In response to doc

QUESTION 153
Which four options are the characteristics of the original 802.11 protocol? (Choose four.)

A. Defined DSSS and FHSS as possiblemethods for modulation
B. Designed to operate in the 5 GHz ISM frequency spectrum x
C. The most common deployment is three non-overlapping channels that are 20 MHz wide
D. The protocol sets the maximumthroughput at 1 Mb/s or 2 Mb/s
E. Defined FHSS and OFDM aspossible methods for modulation
F. The most common deployment is three non-overlapping channels that are 22 MHz wide
G. Designed to operate in the2.4 GHz ISM frequency spectrum
H. The protocol sets the maximum throughput at1 Mb/s

Shouldn’t this answer be A,D,F,G? (Instead of ACFG). OFDM is 20mhz, but the other’s are 20mhz.

In response to DOC

QUESTION 75
When an AP, in its default configuration mode, connects to a Cisco WLC, which methods are
available for remote management access to an AP?

A. SSL and SSH are available only after configuration by a Cisco WLC version 7.0.
B. SSH only
C. HTTPS, and SSH
D. SSH and Telnet
E. SSH and Telnet are available only after configuration by a Cisco WLC version 7.0.

Correct Answer: Should be E (Documentation and googling question confirms this)

Wasnt OFDM added later?

Pretty sure the original 802.11 protocol only had DSSS and FHSS

@Chuck,

Look at this(specifically the table);
https://en.wikipedia.org/wiki/IEEE_802.11

Original 802.11
1mpbs and 2mpbs
22mhz
DSSS & FHSS
2.4Ghz

Answer is ADFG

Looks Ok to me.

Hopefully that is what the are asking

411 Question Fix;
QUESTION 32
A customer wants to deploy Cisco Cloud Wireless architecture with 802.11ac capabilities. Which two access
points would meet the customer’s requirements? (Choose two.)

Correct Answer should be: B,E (Previously A,E, But 3700 AP’s are AireOS, they do not work for cloud)

411 Question Doubt,
QUESTION 142
Current answer is D. But I guess the correct answer should be C. Can somebody check it please?

anybody has vce for all the questions? i’m planning to take this exam next month. please help.

Finally Passed 200-355 exam yesterday by learning PassLeader 200-355 dumps, 100% valid now!

P.S. PassLeader 200-355 dumps: https://drive.google.com/open?id=0B-ob6L_QjGLpcXZkRGszbGJmUkE

more thanks itzik shliselberg for your update and more Congratulation

@ itzik shliselberg
Can you please add here what are the new questions you got which are not in PassLeader 411Qs? I am taking exam this Friday. Please help

@itzik shilselberg

Would you be able to verify if you saw the same questions from your test on this doc ?????
Any drag and drop questions ? How many total questions in the test
Thanks in advance

https://drive.google.com/file/d/0Bx7fP4On5BVleUlxblFNUERwZDQ/view?usp=sharing

@Steven
Which VCE player are you using for the VCE files from examforall?
I have them too and trying to use A+ VCE player with Bluestacks, but the app just saying that my app is old and I need to update, but I have the latest.

@ itzik shliselberg
plsssssssssss …what about drag&drop questions ?

does anyone has the vce format of the 411Qs, 103Qs, and 291Qs? Please post in this forum.

Can anyone who took exam recently confirm if material is accurate for new questions?
My impression is that “itzik” is just a spam for Passleader

@W0rri3d, we should be worried. There is no material 100% guarantee as cisco changed the pool of questions. You can use 411Q and 103Q to study with the certification guide. But the dumps it’s 100% and 411q has a lot of older questions who is not in the exam, also there is some new questions that we don’t know.

the dump it’s NOT 100%* and 411.q….

@Guilherme1846
you are meaning 291Q ????

291Q is actually 411Q uncompleted.

my dear Guilherme1846
plsssssss
if i studied from 291Q it’s enough

@Cisco Man, no it’s not enough.

You have to study Certification Guide, 103Q and 411Q (Which includes 291Q), and also be aware for new questions which we don’t know yet.

@Guilherme1846
ok… exam include drag &drop ???

Anyone Test Recently this form has become pretty dead lately…

Agree with Mike, I will be taking the exam on Friday and will provide some comments after that.
I am going through 103Q, 411Q and new questions posted in the forum. Hope it will be alright.