Share your WIDESIGN Experience

IPv6 source guard is an interface feature between the populated binding table and data traffic filtering. … When traffic is denied, the IPv6 address glean feature is notified so that it can try to recover the traffic by querying the DHCP server or by using IPv6 ND

RA throttling allows the controller to enforce limits to RA packets headed toward the wireless network. By enabling RA throttling, routers that send many RA packets can be trimmed to a minimum frequency that will still maintain an IPv6 client connectivity.

IPv6 RA Guard. The IPv6 RA Guard feature provides support for allowing the network administrator to block or reject unwanted or rogue RA guard messages that arrive at the network device platform. RAs are used by devices to announce themselves on the link.

IPv6 DHCPv6 Guard is one of the IPv6 FHS (First Hop Security) mechanisms and is very similar to IPv4 DHCP snooping. This feature inspects DHCPv6 messages between a DHCPv6 server and DHCPv6 client (or relay agent) and blocks DHCPv6 reply and advertisements from (rogue) DHCPv6 servers.

(There does not seem to be anything called “aaa override for ipv6 acl”)The AAA Override option of a WLAN enables you to configure the WLAN for identity networking. It enables you to apply VLAN tagging, Quality of Service (QoS), and Access Control Lists (ACLs) to individual clients based on the returned RADIUS attributes from the AAA server.

IPv6 Bridging. … It is designed to help organizations with their migration to IPv6, while integrating naturally with any IPv4 network. The system is fully dual-stack, with all middleware services developed from the ground up to be IPv6 capable

Understanding IPv6 ACLs. A switch supports two types of IPv6 ACLs: IPv6 router ACLs are supported on outbound or inbound traffic on Layer 3 interfaces, which can be routed ports, switch virtual interfaces (SVIs), or Layer 3 EtherChannels. IPv6 router ACLs apply only to IPv6 packets that are routed.

3 passed today too in Brazil

ebay.to/2nR8a03

Updates : 13th December 2018

Valid dumps

Good luck

also it looks like question “Exam A Q134” is wrong, the question is asking “coverage requirements” dump says answer “C. authentication type” and E. devices types are the correct ones.
Answer C. dose not make sense this does not affect coverage requirements, Answer D. number of users would make more scene for a answer.

Do you recall seeing a question and the answers included—at least 20, max 20?

Thanks all I can recall

Test

Not letting me post questions

What about answered dish & Yagi or is it Patch and Yagi?

Which 4 areas of WiFi should be examined during an upgrade design.
RF, Bandwidth, coverage, scalability, Roaming, Cost

Which layer do you place you WLC?
Core, Access, Distribution

Customer has determined that a cable run for a low throughout RF design is not economically feasible to install. Which 2 access point mode can alleviate customer concern?
Bridge, sniffer, flex-bridge, flex connect, local

802.11n implementation is discussed. Users satisfied with potential 300-400 MPs throughput in new 802.11n APS. Which 3 bandwidth are used to calculate?
450, 300, 100?

Customer is deploying a greenfield 802.11ac network on floor that will support approximately 300 wireless device. Which setting needs to be changed on prime infrastructure planning tool in order to predict the amt of access point to support new floor?
Demand settings or add AP field

I didn’t pass the exam last week. There were about 10-15 new questions.
For example: When you want to calibrate a floor plan in PI, what has to be disabled on the WLC? Whats is right?

KFC
I failed last week as well. 10-15 new questions
Some listed above

Passed too (980/1000)

I used the dumps posted by Elisabette above

ebay.to/2nR8a03

Updates : 10th December 2018

Valid dumps

Good luck

Congrats!!! Passed the 300-360 exam on 14/Dec/2018!!!

A lot of new questions appeared in my actual 300-360 test, old version 300-360 dumps are NOT valid enough for passing now! DO NOT WASTE TIME ON THEM!!!

And, I learned the latest PassLeader 300-360 dumps with 185q (Updated Recently), almost all NEW questions are available in PassLeader, stable and valid enough for passing!!!

Good luck, all!!!

p.s.

Part of PassLeader 300-360 dumps FYI:

drive.google.com/open?id=0B-ob6L_QjGLpWVVreDl3bGRhakk

Part of PassLeader 300-365 dumps FYI:

drive.google.com/open?id=0B-ob6L_QjGLpR3dFYkJubjFZaDQ

Good luck!

More:

Part of PassLeader 300-370 dumps FYI:

drive.google.com/open?id=0B-ob6L_QjGLpM3ZXaF9TdmZSeUU

Part of PassLeader 300-375 dumps FYI:

drive.google.com/open?id=0B-ob6L_QjGLpQ2hZQ0c4c2d1QjA

Good luck!

Passed too (980/1000)

I used the dumps posted by Elisabette above

ebay.to/2nR8a03

Updates : 10th December 2018

Valid dumps

Good luck

sorry forgot to say that the last part is for the new slider question on IPv6

Teejey
Not sure I agree with your answer A. 70 for the max 5e cable length.
The max length is 100m
I did look that up.
Any advice on the questions I posted?
Have u seen any other new questions and courious are u I’m US?
I wonder if some of these post are testers outside US as test might be different
I plan to retest end of wee—u?

Here are my answers to the questions listed above:
add AP Field /450,300,100 / Bridge, Flex+Bridge / Distribution Layer / Patch, Yagi / max. 20 / RF, Bandwidth, coverage, Roaming / -75 to -67 dBm.
What do you mean?
Do you have any idea regarding the above question to PI?

Teejey you are doing a great job, thanks for the great support!
men this is highly appreciated!

Thanks KFC
I did try to look up that floor calibration — I found some stuff about toggle on and off unsupported access points
Do u recall the answers????

Where to place WLC core or distribution?
I saw points for both but then I read more often than not it’s core

Jod

usually the are install in the service layer, which it is the core layer.
check the following link;
http://what-when-how.com/deploying-and-troubleshooting-cisco-wireless-lan-controllers/controller-placement-cisco-wireless-lan-controllers/

TPC, Clean Air, CHD. I forgot the fourth one.

Mse???

I received a good news today, passed the 300-135 exam, and shared this good luck website with you http:t.cn/EUkfZ8S, good luck!

— Passed too this morning (933/1000) —

I used those dumps, you can rely on them to pass the exam

ebay.to/2nR8a03

Good luck

I cannot post as teejey site blocks me

the whole question was not posted, i have found it now and it asked for 5 Gig connection.
New Question 196
A network engineer is retrofitting an existing building wired with category 5e with AP 3800 and mGig switches. What is the maxium cable length to support a 5G solution?

A. 70 m
B. 120 m
C. 130 m
D. 150 m
E. 100m

Answer: A

Teejey have you found any other new questions? Please post.
Also see new question from KFC on 12/16 about calibrating floor plan.

@Teejey
the link that you posted from the above cannot be open, can you give the permission?

@ Teejey

can you please give the permission to your following link url?
https://drive.google.com/file/d/1pinAk76mA8qc-cabWtVwYSr7sY-_FZXY/view?usp=sharing

thanks

Anyone have this question/know answer?
What is the help database for invention is of RFID devices?
RTLS, CWCS……

KFC
Did you found the answer to you floor clabration question?
I have not been able to find it

No, I suspect TPC. I have no answer to your question.

Yesterday passed the 300-101 exam, now share this good luck learning materials website, http:t.cn/E4AShqz is a wonderful day!

I passed the 300-135 exam today and it is passed in
Http:t.cn/E4AShqz This website has enabled me to pass the exam smoothly. A beautiful day begins with a beautiful transcript. I wish you a smooth exam.

— Passed too this morning (933/1000) —

I used those dumps, you can rely on them to pass the exam

ebay.to/2nR8a03

Good luck

Hi
anyone recommend lead2pass?
contains 185 Q/A.

thanks

There is a study material about ISC2 CIThere is a study material about ISC2 CISSP, now I recommend it to you http:t.cn/E44bxmRSSP, now I recommend it to you http:t.cn/E44bxmR

I heard that there are the latest 300-101 learning materials.
  Http:t.cn/E4AM8xI After I saw it, I passed the exam smoothly, a beautiful day.

A company has deployed a centralized wireless architecture in their headquarters. In this type of
deployment, to which network layer do you recommend that the WLC connect?
A. distribution layer
B. Data center layer
C. session layer
D. access layer
Anyone know correct

In the training documents it means “Campus Services”, then maybe Data Center

I passed it!! I used the current passleader ver 18.09, this is only lets me post once a day with very little info
WRONG Answer: QUESTION 156
B. SE-connect
https://support.metageek.com/hc/en-us/articles/203794964-What-is-the-Cisco-CleanAir-Accessory-
OOPS, forgot to fix this on answer B.

you perform initial RF plan for a site using Cisco PI. What 2 actions improve real time hand off?
RRM and RTTs??

Teejey can you provide any new questions u saw?

KFC I think it might be access:
•Centralized WLC deployment—WLCs are placed in a centralized location in the network where most LWAPP tunnels between APs and WLCs must traverse the campus backbone network. A schematic of a centralized WLC deployment is shown in Figure 2-14. Note that the centralized WLC (a pair of WiSMs enabled 6500s in this case) are not shown in a specific building. The centralized WLC cluster would typically be attached to the campus core in the same building as a data center, but not in the data center because the network and security requirements of a data center are generally different to that of WLC cluster.

The centralization of the WLCs is attractive and is a general recommendation, and the WiSM makes a good choice in this environment. When planning a centralized WLC deployment, consideration should be given to the protection of the network directly connected to the WLC, because the WLC is fundamentally connecting an access network to this network device, and all the security considerations associated with an access layer network device need to be considered. For example, in a WiSM deployment, features such as Denial of Service Protection and Traffic Storm Protection should be considered given the central role of its devices in providing a WLAN service to many users, and the potential for clients with varying levels of security connecting to the switch backplane.

After the actual operation, tell me that CCIE security workbook can be downloaded from this website http:t.cn/EUkfZ8S