Share your ENWLSD Experience

i have contacted h0mer. he said dump is unstable

@aomi
Is it unstable because of wrong answers or because new questions?

both

Well, I am confident on my knowledge so
I guess I will take it to see how it goes.

No you dont David.
This homer guy is a bad dump seller

Can you share about new questions please

Hi all,
I passed the exam. It was not a very high score but a pass is a pass!
Many of the questions were in these dumps but many were wrong, so I had to correct them!
2-3 questions were new as I did not know how to answer them properly.
Good luck to all.
Study hard and you will pass!

Could you tell us which questions are wrong? Thanks.

A company has 10 access point licenses availabe on their backup Cisco WLC and their primary CISCO WLC is at full capacity. 5 access points are set to hiighr failover priority and 7 APs are set to Critical failover. During a failiure, not all critical APs failed over to the backup WLC. Which configuration is the cause of this issue ?
1- The high prioroty Ap is oversubscribed
2- Network ap-priority is set to enable
3- The critical priority access point count is oversubscribed
4- network ap-priority is set to disabled.
What do you think guys ?

network ap-priority is set to disabled.

i mean ENWLSD 300-425. score 87x

A network administrator of a global organization is collapsing all controllers to a single cluster located in central Europe. Which concern must addressed?
A. Some channels may not be available consistently across the organization.
B. Different RF policies per office are not available in this configuration.
C. Syslog must be configured to the time-zone of the NMS platform.
D. Centralized controllers cannot uniformly authenticate global users.

Answer: C

I believe the answer is A since it is a global organisation and not all channels are available in all countries, for example 2.4ghz channels in UK are 1-13 and US are 1-11

Answer to Tipsy’s question. I’ve also think the answer could be A.
Exam has usually 60-61 questions and 1.5 hours. Dumps are not valid even the questions with 80. Only few of them will appear and most of the answers are wrong. new questions are there about load balancing (round robin), Se connect, antenna gain requirements for design etc.

@TEST1

how do you know dumps are invalid have you done the test recently?

.

Stiil valid dumps available with the right Q’s and A’s ?

@Emma please share again

Failed exam recently. Many of the questions above were on the exam but a lot of the answers are wrong

.

Hey Guys! Where do you get the premium file from ?

Can someone give me the correct answer please for this question.
A wireless engineer is designing a wireless network to support real-time applications over wireless.
Which IEEE protocol mus the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
A. 802.11w
B. 802.11r
C. 802.11i
D. 802.11k

I think the answer should be D) 802.11k – as this protocol does channel selection, roaming and TPC.

What is the correct answer for this question please

47. A network engineer is working on a design for a wireless network that must support data, voice, and location services.
To support these services, which access point placement must the engineer use?
A. corner only
B. perimeter and corner
C. perimeter only
D. indoor and outdoor

Is it C. Perimeter only or B. Permeter and corner

What is the correct answer for this question, please

55. An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets.
Clients will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the corporate WLAN?
A. WLC port groups
B. RF groups
C. AP groups
D. interface groups

Just answering the person with the name tipse, the answer to this question is C. The reason is the access points for each region has their own regional code and those channels will be disabled by default so the as engineer you do not have to worry about channels.

A network administrator of a global organization is collapsing all controllers to a single cluster located in central Europe. Which concern must addressed?
A. Some channels may not be available consistently across the organization.
B. Different RF policies per office are not available in this configuration.
C. Syslog must be configured to the time-zone of the NMS platform.
D. Centralized controllers cannot uniformly authenticate global users.

Scor can you share the dump with me please. zunang11atgmaildotcom

[spam_suspect][spam_point:3][spam_suspect badword:tk]Passed this exam.
A lot of new question that is not in this forum.
You can download it from below link.
Not sure about the answer

https://drive.g**gle.com/file/d/1xGF7HTkffzvDm9IKLpcJy8QTGJ2DsdWT/view?usp=sharing

Any update for dump?

Passed this exam.
A lot of new question that is not in this forum.
You can download it from below link.
Not sure about the answer

John can you share the link with me at soccer7806atgmaildotcom

What is the correct answer for this question please

47. A network engineer is working on a design for a wireless network that must support data, voice, and location services.
To support these services, which access point placement must the engineer use?
A. corner only
B. perimeter dand corner
C. perimeter only
D. indoor and outdoor

Is it C. Perimeter only or B. Permeter and corner

Can someone give me the correct answer please for this question.
A wireless engineer is designing a wireless network to support real-time applications over wireless.
Which IEEE protocol mus the engineer enable on the WLC so that the number of packets that are exchanged between an access point and client are reduced and fast roaming occurs?
A. 802.11w
B. 802.11r
C. 802.11i
D. 802.11k

I think the answer should be D) 802.11k – as this protocol does channel selection, roaming and TPC.

ScorJune 16th, 2021
What is the correct answer for this question please

47. A network engineer is working on a design for a wireless network that must support data, voice, and location services.
To support these services, which access point placement must the engineer use?
A. corner only
B. perimeter and corner
C. perimeter only
D. indoor and outdoor

Is it C. Perimeter only or B. Permeter and corner

ScorJune 16th, 2021
What is the correct answer for this question, please

55. An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets.
Clients will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the corporate WLAN?
A. WLC port groups
B. RF groups
C. AP groups
D. interface groups

ScorJune 16th, 2021
Just answering the person with the name tipse, the answer to this question is C. The reason is the access points for each region has their own regional code and those channels will be disabled by default so the as engineer you do not have to worry about channels.

A network administrator of a global organization is collapsing all controllers to a single cluster located in central Europe. Which concern must addressed?
A. Some channels may not be available consistently across the organization.
B. Different RF policies per office are not available in this configuration.
C. Syslog must be configured to the time-zone of the NMS platform.
D. Centralized controllers cannot uniformly authenticate global users.

guys

where can i get dumps for this exam please ?

thank you all

Can anyone provide a valid dump, need to take this exam asap.

Thanks in advance.

47. A network engineer is working on a design for a wireless network that must support data, voice, and location services.
To support these services, which access point placement must the engineer use?
A. corner only
B. perimeter and corner
C. perimeter only
D. indoor and outdoor

Answer is B

A customer has noticed that Client Band Select is enabled and no clients are utilizing the 5 GHz band. Which three parameters must be met to ensure that wireless clients use the 5 GHz band? (Choose three.)

A. Ensure that channel bonding is enabled on the WLAN.
B. Ensure that the co-channel interference has not exceeded −85 dBm.
C. Ensure that the UNII-2 extended channels are enabled on the 802.11a radios.
D. Ensure that the client is receiving RSSI above the minimum band select RSSI threshold.
E. Ensure that the client is dual-band capable.
F. Ensure that the WLAN has 802.11a enabled.

Correct should be D,E,C but i believe that it is not C but F.

I have tried to disable UNII-2 extended channels and enable Client Band Select for particular SSID under WLC and no error appeared. Also there is no information regarding to UNII-2 extended channels vs Client Band Select

what do yo think?

thanks

Hey guy that you have passed the exam with 967points, could you please send me the file to freetx[at]seznam[dot]cz please?

A network engineer is designing a new wireless network. The network needs to have these characteristics:
support high client concentration
optimize client performance
avoid interference
Which approach should be taken?
A. Deploy APs near each other for 2.4 GHz coverage, and disable the 5 GHz radios for all APs.
B. Deploy APs near each other for 5 GHz coverage, and disable the 2.4 GHz radios for some APs.
C. Deploy APs near each other for 2.4 GHz coverage, and disable the 5 GHz radios for some APs.
D. Deploy APs near each other for 5 GHz coverage, and enable the 2.4 GHz radios for all APs.

does anyone knows?

Hello Team,

Can whoever has the latest dump share at bahati_reneAyahoo.com,

Cheers,

I just took the test, I failed 79xx, there are a lot of new questions that are not here and in any dump I bought, this was my second attempt

Does anyone have an updated dump or indicate a site that has it?

@FredyeM – could you give us example of new questions please? I didn’t find any page where are some new questions.

I failed the exam. 40% new questions, I cant really remember the new questions now, but they aren’t much different from the dump. I depended too much on the dump, so don’t be like me.

HI everyone, does anyone has the official cer guide for 300-425 and 300-430? i looking everywhere but not find any.

@FredyeM: which dump file did you use ? the 93Q with corrected answers ?

@Hamoze: can you share the 93Q wiht me, soccer7806atgmaildotcom

15 new questions that i havent find it – unfortunately i failed it

@anonymous : the 15 new questions are not in the 93Q dump shared by Mike ?

https://drive.g**gle.com/file/d/1xGF7HTkffzvDm9IKLpcJy8QTGJ2DsdWT/view?usp=sharing

Hey all
I passed my exam today with a good mark (980/1000)
All the questions and drag & drop were from this dump.
kurzelinks.de/mr64
You can rely to this dump to pass the exam with a good mark.
Good luck on the exam
Regards,

Hey all
I passed my exam today with a good mark (980/1000)
All the questions and drag & drop were from this dump.
kurzelinks.de/mr64
You can rely to this dump to pass the exam with a good mark.
Good luck on the exam
Regards,

PassLeader have a new dump with 113Q ,, maybe the new questions are included with it, anyone have it ?

Anonymous is fake fake ,,,,

A network engineer is designing a new wireless network. The network needs to have these characteristics:
support high client concentration
optimize client performance
avoid interference
Which approach should be taken?
A. Deploy APws near each other for 2.4 GHz coverage, and disable the 5 GHz radios for all APs.
B. Deploy APs near each other for 5 GHz coverage, and disable the 2.4 GHz radios for some APs.
C. Deploy APs near each other for 2.4 GHz coverage, and disable the 5 G

Passed today the premium is valid no new question

get premium follow the below

????????????????.????????